My Account | Login | Checkout

You are not logged in

Enter the search term for the product you are looking for below:

More Options
Display my previous orders

To repeat a previous order in part or full, click the link above. To purchase or view any of the items you have purchased before, simply select it from the list below.

75 A AMP - 3 PHASE Bridge Rectifier AC to DC for WIND

75 A AMP - 3 PHASE Bridge Rectifier AC to DC for WIND


Available in increments of 1
Total Percent Off Per Unit
$14.39 0% $14.3900
$27.34 5% $13.6705
$64.76 10% $12.9510
$122.32 15% $12.2315
$230.24 20% $11.5120

75  Amp  Continuous, 150 Amp surge, 3 Phase rectifier

Converts three phase AC to DC

Works with 12 volt and up Alternators


The rectifier is capable of running at 75 amps continuous and 150 amps surge at nearly any voltage a wind turbine might produce providing you mount it to an adequate heat dissipation material or allow it to have some air flow. A 24v wind turbine will probably produce around 40 volts with a moderate wind. This rectifier at 75 amps would allow 3000 watts of power at 40 volts.

The rectifier itself uses 6 diodes rated at 50 amps each. Theoretically, it could handle even more than 150 amps but cooling must be taken into account and is actually the limiting factor. Most other rectifiers being sold as "35 amp rectifiers" use only 25 amp diodes. This rectifier is more than double that capacity due to both the doubled capacity of the diodes as well as the larger, staggered finned area. Notice the staggering in the fins, this allows for better cooling than straight fins.


3 Phase rectifiers are used with 3 phase alternators such as 3 phase wind turbines or hydro electric alternators. The rectifier converts the 3 phases of A/C (alternating current), to D/C (direct current), that can then be used to charge batteries or run D/C appliances. 

Please note: This rectifier has been rated based on information obtained from the manufacturer, who may (or may not have) have assumed a steady air flow to allow proper cooling. We have not personally tested this unit at 75 amps steady without air flow, but plan to do so in the next few days. If you will be using this rectifier at higher amperages, or in connection with a wind turbine (or any other device that requires a load at all times to prevent failure) then we recommend it be mounted to a metal surface, or that you provide forced air flow to insure heat dissipation.

Customers who bought this item also bought

Coleman Air C160M 12v/24v 160A 160 AMPS Charge controller & Meter
160 Amp 12/24 volts. Wind/Solar Diversion-Charge Load Controller with Meter
3600 watts  User settable trip point.
Now with direct relay termination lugs.

click to see more

Truck Star 150 Amp Circuit Breaker, Push-to-Trip Manual Reset

click to see more

3 Three Phase Wind Turbine Disconnect Switch with Brake

click to see more

6 Inch 24 Volt DC Submersible Water Heater Element
24 Volt DC low voltage submersible water heater element - Available in 400, or 600 Watt.

click to see more

36 A Amp /48 V Volt 2160 Watt Diversion Dummy Load Resistor Radiant Air Heater
36A/48V 2160 Watt Diversion Dummy Load Resistor Heater
For 48 volt systems - Now with custom made, Kanthal-A1 wire wound resistors.

click to see more

Featured videos

Coleman Air Products

Copyright 2010-2017 Coleman Air, Inc. All rights reserved.

Have Questions? -- Please call us at 1-800-577-4169

We verify orders.

In addition to standard credit card verification procedures which insure the credit card is not stolen, we also verify the computer IP address, phone numbers, etc., to ensure the person placing the order is not doing so for fraudulent purposes. We work with all applicable agencies to prevent and/or report fraudulent or suspicious activity.

Official PayPal Seal